#Motherboard vs hard drive install

#Motherboard vs hard drive install

The cables also transfer data much faster (more crucial if you have two or more hard drives) and are easier to install since their are no jumpers. It can reach further then a IDE cable and will also reduce the obstruction to air cooling which IDE cables can contribute to. In summary of SATA vs IDE, the SATA cable is smaller, faster and therefore better. If you are new to computers then a SATA hard drive will be easier to install. With SATA there is only the one cable so there are no jumpers to mess around with. With the IDE cable you need to always mess around with the jumpers since their may be two hard drives or two CD drives or one of each on the one cable. IDE vs SATA in the aspect of jumpers again goes the way of SATA.

SATA however data transfer speeds range from 150MB/sec to SATA II which doubles it to 300MB/sec. Generally the high end of the feature spectrum includes enterprise-class SAS hard drives, and the low end includes desktop-class SATA drives. (Typical MTBF, operating temperature, and operating rotational vibration vary depending on the manufacturer). IDE (PATA) transfers data from the speeds of 5MB/sec up to 133MB/Sec (ATA100/133). Vendor implementations of these features vary between drive models. The next step in IDE vs SATA is to work out the data transfer speeds. The PATA or IDE cables are only 45cm long and can connect two hard drives to the motherboard while the SATA cable connects only one hard drive to the motherboard. The SATA cables are also longer then the ribbon cables (some up to 1m) which make them more useful in large cases.

The SATA cable or Serial ATA cables are only 7 pins wide compared to the IDE Ribbon Cable which is 40 pins. SATA vs IDE? WhatвЂ™s the difference and whatвЂ™s better? This page will explain the differences and the pros and cons of each cable.